RKS digital display. Also compatible with 3rd Generation Byqee Conversion Kits

⚙️ Core Parameter Settings

• P01 – Display brightness: 1 (lowest) – 3 (highest)
• P02 – Distance unit: 0: KM | 1: MILE
• P03 – System voltage: 24V / 36V / 48V / 60V
• P04 – Auto sleep timer: 0: Off | 1-60 minutes
• P05 – Number of PAS levels: 0: 3 levels | 1: 5 levels
• P06 – Wheel diameter: 5.0 – 50.0 inches (0.1 increments)
• P07 – Speed sensor magnet count: 1 – 100 (multiplied by the ratio on geared motors)
• P08 – Speed limit: 0 – 100 km/h (100: unlimited)

🔧 Riding and Signal Settings

• P09 – Start mode: 0: Start from zero | 1: Direct start
• P10 – Riding mode: 0: Pedal assist only | 1: Throttle only | 2: Both active
• P11 – Pedal sensitivity: 1 – 24
• P12 – Start intensity: 1 – 5
• P13 – Pedal sensor type: 5 / 8 / 12 magnets
• P14 – Current limit: 1 – 20A
• P15 – Low voltage protection: (Controller limit)
• P16 – Reset total distance: hold the button for 5 seconds
• P17 – Cruise control: 0: Off | 1: On (Protocol 2 only)
• P18 – Speed display ratio: Adjustable
• P19 – PAS level 0: 0: Visible | 1: Hidden
• P20 – Protocol selection: 0: Protocol 1 | 1: Protocol 2 | 2-3: Reserved

🕹️ Entering the Menu and Changing Settings

With the device switched on UP + POWER buttons at the same time.
Use short presses to move between menu items.
After changing the settings, long-press the same buttons again to exit.

P16 screen, the total distance can be cleared but not edited. To clear it, hold the button for 5 seconds.

📌 Notlar

• P06 and P07 values are entered incorrectly, the speed reading may drift.
• When the mile unit is selected, the speed display switches to miles, but the P08 setting stays in kilometres.